|
The AWD-Gladiator is our lowest inertia AWD Chassis Dynamometer Product. The system includes two sets of low-profile rollers; one fixed and the other mounted to a rail with an electronic wheelbase adjustment.
The Gladiator system is particularly suited to testing purpose built high performance AWD automobiles, such as the Subaru WRX STI and Mitsubishi Evolution.
Speed synchronization is achieved by utilizing two PAUs, one for the primary and one for the secondary roller set. By adjusting the load of the second PAU, the speed of the secondary roller set can be controlled to match the speed of the secondary roller set, which is effective in achieving a balanced load across both axles and the vehicle drivetrain and for minimizing front to rear speed (MPH) bias.
The AWD Gladiator Model comes with a pair of 140 Model Eddy Current Power Absorbers – each with a maximum load capacity of 625 horsepower per PAU for a total load capacity of 1,250 hp and a total power measurement capacity of 1,000 hp per axle, or 2,000 total.
Specifications
| Horsepower: |
1,250 hp peak absorption AWD (625 hp 2WD)
2,000 hp peak measurement AWD (1000 hp 2WD)
|
| Loading: |
Air cooled eddy current power absorber (2x K140)
|
| Maximum Speed: |
150 mph
|
| Inertia: |
630 lbs. (286 kg) base mechanical inertia (2WD Mode)
1,260 lbs. (572 kg) base mechanical (AWD Mode)
|
| Controls: |
DAC based controller with POWERDYNE™ control software
|
| Remote Control: |
Infrared, for remote operation with wireless keyboard
|
| Axle Load: |
Manual axle pull down included
|
| Rolls: |
Precision machined & dynamically balanced
Front roll set may be grooved horizontally
8.575” (218mm) diameter balanced rolls
35” (889mm) face length
30” (762) inner track width (Exceeds EPA/BAR Standards)
100” (2,540mm) outer track width
17.1” (434mm) roll spacing
88.5” - 141” Wheelbase accommodation
Electronic Wheelbase Adjustment
Side to side coupled rollers to prevent damage to traction control
|
| Frame: |
Heavy-duty structural steel frame
Heavy-duty restraint kit included
|
| Roller Exit: |
Between roll lift with integrated roll lock
|
| Axle Weight: |
6,000 lbs maximum
|
| Shipping Weight: |
3,000 lbs (dyno only)
|
| Air Requirements: |
80 PSI, dry, regulated, oil free
|
| Power Requirements: |
115 VAC single phase, 60 Hz, 15 Amps (Computer)
230 VAC single phase, 60 Hz, 30 Amps (dyno controls)
|
| Options: |
• OBD Interface
• Engine RPM Module
• Manifold Pressure Sensors
• Lambada Meter
• 5 Gas Analyzer
• Color Printer
• Above Ground Ramps
• 5 hp Warm-Up Motor
|
• Cooling Fan (10,800 CFM)
• EGT
• Boost Pressure Sensor
• Weather Station
• Opacity Meter
• Advanced Data Acquisition
• 50 Hz System
|
|
Enquire about this dyno
Other Dynos
|
AWD Gladiator
